Spotlight Cam Mount Installation

Installing your Ring Spotlight Cam Mount is a simple process. The steps below will help you prepare and mount your Spotlight Cam.

Step One - Select Your Location to Install Your Spotlight Cam


Select a location to install your Spotlight Cam. It's important when selecting a location to remember that Spotlight Cam is designed to be placed at an optimum height of nine feet with the motion detector parallel to the ground. This will put the motion sensor in a perfect position to detect human-sized objects at up to 30 feet.


Also note that you'll need to decide whether you're going to be mounting your Spotlight Cam on the wall or on the ceiling.

  • When mounting the Spotlight Cam to a vertical Wall, you'll usually want the circular protrusion where you mount the Spotlight Cam facing downwards.
  • When mounting to a horizontal surface, face the circular protrusion in the direction you want the camera to see.
Step Two - Insert and secure the wiring harness


  • Hold the plate that covers the weatherproof box and your Spotlight Cam in the orientation you plan to install them.
  • Feed the wires through, then insert Spotlight Cam into the box cover.
  • Using the nut attached to the base of the camera's arm, secure the wiring harness from the box cover.
  • Once the nut is tightened, turn your Spotlight Cam to the left to disengage it from the mount, and remove it, for now.


Step Three - Shut power off at the breaker


If you don't know where your breaker is or how to turn off power to your electrical box, consult with a licensed electrician.

Step Four - Remove your existing light or camera (optional)


With power off at the breaker, remove your existing floodlight or camera from the electrical box and disconnect the wires.

If there is a bracket attached to your electrical box, remove that as well.

  • Inspect the box to make sure water can't get in. 
Step Five - Hang the box cover


Use the included hanging hook to hold the weatherproof box cover in place as you wire it in.


Step Six - Connect the power wires


Connect the black and white wires on the wiring harness to the black (hot) and white (neutral) wires coming out of your electrical box.

Use the included wire nuts to secure and protect the connections.

The red wire is optional and should be connected only if you wish to control other lights with your Spotlight Cam. If not in use, the red wire must be capped securely with a wire nut.


Step Seven - Screw in the box cover


Use the included screws to secure the box cover to the electrical box. Be sure to ad a metal washer then a rubber washer to each screw before inserting.

Note: Some round electrical boxes may only accept two screws. Seal unused holes in the cover with the included screws and nuts. Add a metal washer backed by a rubber washer to each side before tightening the nut.


Step Eight - Mount your Spotlight Cam


Insert your Spotlight Cam into the box cover. Once it's fully seated, turn to the right to lock it.


Step Nine - Add the security screw


Tighten the security screw on the side to lock your Spotlight Cam to the box cover.


Step Ten - Turn power on at the breaker


Once your Spotlight Cam is installed, it's time to turn the power back on at the breaker. If the lights on your Spotlight Cam turn on, you're ready to go! If not, turn off power at the breaker and check your connections.

Step Eleven - Set up Your Spotlight Cam in the Ring App.


After physically installing your Spotlight Cam, the next step is to set it up in the Ring App.

Click here to learn how to do the in-app setup for the Spotlight Cam Wired.

Join Our Community

Share feature requests, get help, and discuss the latest in security with your fellow users on Ring's first community forum.