Safety and Compliance Information for Power over Ethernet Adapter


WARNING: Small parts contained in the Power over Ethernet Adapter kit may present a choking hazard to small children. Keep small parts away from children and pets. Your Ring Power over Ethernet Adapter should only be used in accordance with the instructions and intended purpose. Using this accessory in any way other than its intended purpose could cause injury to yourself, others or damage to the device. Your Ring Power over Ethernet Adapter is not waterproof and as such should not be submerged in water, doing so could cause injury to yourself, others or damage to the device.

Maintaining Your Adapter

Do not expose your device or adapter to liquids. If your device or adapter gets wet, carefully unplug all cables without getting your hands wet and wait for the device and adapter to dry completely before plugging them in again.  Do not attempt to dry your device or adapter with an external heat source, such as a microwave oven or a hair dryer. If the device or adapter appear damaged, discontinue use immediately.  Use only accessories supplied with the device to power your device.  To avoid risk of electric shock, do not touch your device or any wires connected to your device during a lightning storm.

Do not attempt to clean or polish your adapter with or expose your adapter to oil, lotion, or other abrasive substances.

Use only accessories supplied with your device, or specifically marketed for use with your device, to power your device. Use of third-party accessories may impact your device’s performance. In limited circumstances, use of third-party accessories may void your device’s limited warranty. In addition, use of incompatible third-party accessories may cause damage to your device or the third-party accessory. Read all safety instructions for any accessories before using with your device.

Use this device in dry rooms only. Do not cover the device while operating. Do not open the housing. Protect this device from sunlight. Disconnecting the plug will power the device off. Do not use the device if the plug or housing is defective, there is a risk of electric shock.

Other Safety Considerations

• Do not force the adapter into a power outlet.

• Do not expose the adapter or cable to liquids.

• If the adapter or cable appears damaged, discontinue use immediately.

If this device is used to power other devices, those powered devices must be located near this device.

For device compatibility information, see the detail page for this adapter on

Servicing Your Device

Faulty service may void the warranty.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This Product has been tested and found to comply with the limits for a Class B digital device or external switching power supply, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The Products generate, use and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Pursuant to Section 15.21 of the FCC rules, changes or modifications to a Product by the user that are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

The party responsible for FCC compliance is Ring LLC, 12515 Cerise Ave, Hawthorne, CA 90250

Device Name: Power over Ethernet Adapter (2nd Gen) 

Model: POE15M-1AFE


In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of or recycle the device in accordance with your local laws and regulations. For information about recycling, go to For information regarding Amazon’s recycling program, visit

Model No.: POE15M-1AFE

Input: 100-240 Vac ~ 0.8 A 50-60 Hz

Output: 56 V ⎓0.275 A

Operating temperature: 32F to 104F (0C to 40C)

Terms of Service and Warranty

By purchasing or using this product, you agree to the Terms of Service found at

For information on our warranty or any other applicable policy, visit

Join Our Community

Share feature requests, get help, and discuss the latest in security with your fellow users on Ring's first neighbor-to-neighbor community forum.